2t Marine telescopic hydraulic crane with international brand components

2t Marine telescopic hydraulic crane with international brand components

Product description:
 On a full-powered boom, the sections are extended and retracted (except for the base section) by hydraulicc cylinders, called extension cylinders. The cylinders are mounted parallel to the boom center line within each section. The boom extension cylinders on most telescopic booms have sequencing valves that allow the sections to extend (telescope) by equal amounts. These cranes usually have a single telescope control lever in the crane cabin. However, on cranes not equipped with sequencing valves, the operator will have to extend each section equally. (The crane will have two or three boom telescope control levers in the cab, each controlling only a single boom section.) If the boom sections are extended unequally, the most fully extended section of boom could bend to uneven stresses. Additionally, the load chart will be invalidated for determining rated capacity of the crane. Boom sections that are marked off in equal increments, make it easier for the operator or signalman to make sure each section is extended equally.

General Arrangement:

 

Technial Specification:
 

Our Certificate:

Production process at OUCO workshop:

 
 FAQ:

Q: What’s working radius of your crane?
A: From 1m to 100m, we can design and make according to your requirement.

Q: Which crane type should I choose?
A: We have foldable boom, knuckle boom, telescopic boom, stiff boom, etc.

Q: Can this crane be explosion proof?
A: Sure, we can equip any extra function based on your requirement.

Q: Does your crane have safety devices?
A: Of course, we have all cut off limits and alarms for safety reasons.

Q: How can I install the crane to my vessel?
A: We can send our service engineers to the vessel site for guiding or ship the crane in whole piece.
Anything else? We will be pleased to answer all your questions and doubts.